• LinkedIn Social Icon
  • Facebook Social Icon
Let us assist you in building your world-class lubrication program.

© Copyright 2015 Trilub Limited

RSS Feed

 

 

  • Quick installation (only 3 minutes) - No need to cut open pipes

  • Hydraulic measuring connector serv-Clip® Type 1 No shutdown of installations for mounting on pressurized pipesinstallation of pressure switch, gauge and sensors, particle counters

  • Hydraulic measuring connector serv-Clip® Type 2 Short shutdown of installations for mounting on NON-pressurized add. to type 1- installation of flow rate, leakage, temperature and aqua sensors

  • Working pressure up to 630 bar / 9100 psi -

  • Included screwed coupling M 16 X 2 and Viton O-ring (200°)

  • Particle measurement according to ISO or NAS classes

 

Test Hydraulic measuring connectors serv-Clip ® with our SENSOR proposal:

 

  • pressure  fluid-Check ®

  •  temperature fluid-Check ®

  • flow rate / leakage detection fluid-Check ®

  • aqua fluid-Check ® new 

 

and more... measure immediately, in conjunction with virtually every type of measurement minimess serv-Clip fluid-Check connectors measurement tube hydraulic pipe measuring points sensorscoupling and measuring equipment!

For pipe diameters with DIN / SAE international norms: 

 

  • Metric system 10-42 mm,

  • TUBE - Inches 3/8 - 2

  • PIPE  - R-Inches ¼" - 3"

  • Over 3" (88,9 mm) with adaptor SC-XE-607

 

Hydraulic measuring connectors serv-Clip ® is a patented product and registered trade mark of BOLENDER-Germany.serv-Clip - the multi-measuring connection in 3 minutes installation..The use of the hydraulic measuring connectors serv-Clip does away with installation on more than 80% of all normal measuring points. 

Hydraulic measuring connectors serv-Clip on new system

You have only to make plants to install normal measuring connectorsminimess Hydraulic measuring connectors serv-Clip fluid-Check coupling measurement tube hydraulic pipe measuring points sensors at the necessary measuring points. Hydraulic measuring connectors serv-Clip is installed wherever required. If required, you can perform measurements immediately at any point on the system.

Hydraulic measuring connectors serv-Clip on older systems

It is possible to retrofit hydraulic measuring connectorserv-Clip directly at the necessary points of the system. By means of hydraulic measuring connectors serv-Clip you are able to carry out measurements at any point on the system.

serv-Clip Type 1

Pipe measuring point serv-Clip ® Type 1 (for mounting on pressurized pipes)